TURBO PORSCHE 911 1994 2DR COUPE
Security
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition RED/BLK (+) IGNITION SWITCH HARNESS
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AllDoorTrigger BRN/WHT (-) (-) DRIVER'S PIN SWITCH
TrunkTrigger BRN/RED (-) TRUNK PIN OR FACTORY ALARM
FactoryAlarmDisarm BRN/GRN (-) ALARM MODULE UNDER PASSENGER SEAT
ParkingLights GRY/BLK L (+) AND GRY/RED R AT AT LIGHT SWTCH
Security
Parking Lights
ALSO (+) GRAY/RED-DIODE ISOLATE
Remote Start
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition RED/BLK (+) IGNITION SWITCH HARNESS
Ignition02 + IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 RED/YEL + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 YEL + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
NeutralSafety YEL/BRN (-) (-) SWITCH ON GEAR BOX
Tach GRN (-)"REG" (-) AT COIL OR BRN (-)"" AT COIL
ParkingLights GRY/BLK L (+) AND GRY/RED R AT AT LIGHT SWTCH
BrakeLights BLK/YEL (+) AT BRAKE SWITCH
ReverseLights GRY/BRN (+) (+) AT SWITCH ON PASS OF TRANS.
Horn BRN/WHT (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock BRN/BLU (-) (-) OR DRIVER'S KICK NEGATIVE TRIGGER
PowerLock BRN/GRN (-) (-) AT DOOR LOCK RELAYS "BACK OF CNT CONSOLE
LeftFrontWindow01 LF:BLK/BLU
RightFrontWindow01 RF:RED/BLK
LeftRearWindow01 LF:BLU
RightRearWindow01 RF:RED/WHT
Convenience
HeadLights YEL (+) AT FUSEBOX "LOW BEAM ONLY"
COUPE
Mobile Audio / Video
Battery RED + (+) IGNITION SWITCH HARNESS
Accessory01 RED/YEL + (+) IGNITION SWITCH HARNESS
Ground BRN - (-) RADIO HARNESS
Illumination GRY/BLU (+) RADIO HARNESS
PowerAntenna WHT (+) RADIO HARNESS
FrontLeftSpeakerPos WHT
FrontLeftSpeakerNeg BLK
FrontRightSpeakerPos WHT
FrontRightSpeakerNeg BLACK
RearLeftSpeakerPos WHT
RearLeftSpeakerNeg BLK
RearRightSpeakerPos WHT
RearRightSpeakerNeg BLK
Amp UNDER PASS. SEAT
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
